Linear motion and lifts
8 mm of travel per turn on this 250 mm long, 8 mm lead screw — turns a motor into a lift, slide or linear joint.
Engineering inference
goBILDA
goBILDA 8 mm Lead Screw 250 mm (8 mm lead)
goBILDA 3501-0804-0250 stainless-steel lead screw: 8 mm diameter, 4-start thread at 2 mm pitch for 8 mm of travel per revolution, 250 mm long, 76 g. Pairs with goBILDA 3500-series lead-screw nuts, 8 mm lead-screw-bore hubs and 8 mm bearings for lifts, slides and linear joints; no load or backlash figures are published.
3501-0804-0250Development boardPrice · lowest of 2 sellers$8.99www.gobilda.com · in stock
Buy at www.gobilda.com - www.gobilda.comin stock$8.99
- www.servocity.comin stock$8.99
Motor essentials
Facts about the complete product. Unknown values remain open design questions.
A good fit for
Guidance to help you shortlist. The basis is shown for each recommendation.
Precision positioning (CNC, 3D printers)
8 mm lead gives fine positioning per motor step on a Z axis or positioning stage.
Engineering inferenceNo-load speed, rated performance and stall limits describe different operating points. A stall specification is not a continuous operating rating.
FAQ
goBILDA 8 mm Lead Screw 250 mm questions
How much does the goBILDA 8 mm Lead Screw 250 mm cost?
From $8.99 at www.gobilda.com (2 supplier offers tracked). Prices are observed unit prices before tax and shipping.
What are the goBILDA 8 mm Lead Screw 250 mm dimensions?
8 × 8 × 250 mm. A STEP model is available for enclosure fit checks.
Where does this goBILDA 8 mm Lead Screw 250 mm data come from?
Every value in this record is traced to a source — 3 documents including the board and chip datasheets — with the page and table cited per value. Unknowns are left explicit, never guessed.