Grasping and manipulation
angular gripper that opens to 47.56 mm, servo-driven — bolts to the end of an arm to pick and place.
Engineering inference
ServoCity
ServoCity Sub-Micro Gripper Kit
ServoCity 637104 sub-micro gripper kit: geared jaws for a Hitec HS-55 or HS-5055MG sub-micro servo (not included, A15T spline), open to 47.56 mm between jaw tips, 32.4 × 44.9 mm closed, 4 mm mounting hole, 4.7 g without servo — the smallest, cheapest way to add a claw to a micro robot.
637104Development boardPrice$6.99www.servocity.com · in stock
Buy at www.servocity.com Motor essentials
Facts about the complete product. Unknown values remain open design questions.
A good fit for
Guidance to help you shortlist. The basis is shown for each recommendation.
No-load speed, rated performance and stall limits describe different operating points. A stall specification is not a continuous operating rating.
FAQ
ServoCity Sub-Micro Gripper Kit questions
How much does the ServoCity Sub-Micro Gripper Kit cost?
From $6.99 at www.servocity.com. Prices are observed unit prices before tax and shipping.
What are the ServoCity Sub-Micro Gripper Kit dimensions?
32.38 × 44.87 × 3.2 mm. A STEP model is available for enclosure fit checks.
Where does this ServoCity Sub-Micro Gripper Kit data come from?
Every value in this record is traced to a source — 2 documents including the board and chip datasheets — with the page and table cited per value. Unknowns are left explicit, never guessed.