Robot wiring and sensor chains
4-wire 200 mm adapter (STEMMA QT / Qwiic ↔ STEMMA (JST PH)) — plugs I2C sensors and boards together without soldering.
Engineering inference
Adafruit Industries
Adafruit JST PH to JST SH Cable 200 mm (STEMMA to QT)
Adafruit 4424 JST PH to JST SH Cable 200 mm: 4-wire cable about 200 mm long, JST SH 4-pin female, 1 mm pitch (STEMMA QT / Qwiic) on one end and JST PH 4-pin, 2 mm pitch (STEMMA); wires black GND, red V+, blue SDA, yellow SCL (Qwiic order). Plugs I2C sensors, IMUs and touch boards together without soldering.
4424Development boardPrice$0.95www.adafruit.com · in stock
Buy at www.adafruit.com Motor essentials
Facts about the complete product. Unknown values remain open design questions.
A good fit for
Guidance to help you shortlist. The basis is shown for each recommendation.
No-load speed, rated performance and stall limits describe different operating points. A stall specification is not a continuous operating rating.
FAQ
Adafruit JST PH to JST SH Cable 200 mm questions
How much does the Adafruit JST PH to JST SH Cable 200 mm cost?
From $0.95 at www.adafruit.com. Prices are observed unit prices before tax and shipping.
Where does this Adafruit JST PH to JST SH Cable 200 mm data come from?
Every value in this record is traced to a source — 2 documents including the board and chip datasheets — with the page and table cited per value. Unknowns are left explicit, never guessed.
Sources
- Adafruit JST PH to JST SH Cable 200 mm (STEMMA to QT) datasheet — Adafruit Industries
- www.adafruit.com listing