Robot wiring and sensor chains
4-wire 200 mm jumper (STEMMA QT / Qwiic) — plugs I2C sensors and boards together without soldering.
Engineering inference
Adafruit Industries
Adafruit STEMMA QT Cable 200 mm (JST SH 4-pin)
Adafruit 4401 STEMMA QT Cable 200 mm: 4-wire cable about 200 mm long, JST SH 4-pin female, 1 mm pitch (STEMMA QT / Qwiic) on one end and the same connector on the other; wires black GND, red V+, blue SDA, yellow SCL (Qwiic order). Plugs I2C sensors, IMUs and touch boards together without soldering.
4401Development boardPrice$1.25www.adafruit.com · in stock
Buy at www.adafruit.com Motor essentials
Facts about the complete product. Unknown values remain open design questions.
A good fit for
Guidance to help you shortlist. The basis is shown for each recommendation.
No-load speed, rated performance and stall limits describe different operating points. A stall specification is not a continuous operating rating.
FAQ
Adafruit STEMMA QT Cable 200 mm questions
How much does the Adafruit STEMMA QT Cable 200 mm cost?
From $1.25 at www.adafruit.com. Prices are observed unit prices before tax and shipping.
Where does this Adafruit STEMMA QT Cable 200 mm data come from?
Every value in this record is traced to a source — 2 documents including the board and chip datasheets — with the page and table cited per value. Unknowns are left explicit, never guessed.
Sources
- Adafruit STEMMA QT Cable 200 mm (JST SH 4-pin) datasheet — Adafruit Industries
- www.adafruit.com listing