Robot joints and actuation
8 mm bore deep groove ball bearing (22 mm OD) supports a rotating shaft or joint and takes the load off the motor.
Engineering inference
goBILDA
goBILDA 8×22×7 mm Ball Bearing (2-pack)
goBILDA 1600-0722-0008 non-flanged radial ball bearing, sold as a 2-pack: 8 mm bore, 22 mm outer diameter, 7 mm wide, high-carbon steel, 11 g each. Fits goBILDA 8 mm shafting and 8 mm lead screws and presses into skate-wheel hubs; load ratings are not published by the maker.
1600-0722-0008Development boardPrice · lowest of 2 sellers$3.99www.gobilda.com · in stock
Buy at www.gobilda.com - www.gobilda.comin stock$3.99
- www.servocity.comin stock$3.99
Motor essentials
Facts about the complete product. Unknown values remain open design questions.
A good fit for
Guidance to help you shortlist. The basis is shown for each recommendation.
No-load speed, rated performance and stall limits describe different operating points. A stall specification is not a continuous operating rating.
FAQ
goBILDA 8×22×7 mm Ball Bearing questions
How much does the goBILDA 8×22×7 mm Ball Bearing cost?
From $3.99 at www.gobilda.com (2 supplier offers tracked). Prices are observed unit prices before tax and shipping.
What are the goBILDA 8×22×7 mm Ball Bearing dimensions?
22 × 22 × 7 mm. A STEP model is available for enclosure fit checks.
Where does this goBILDA 8×22×7 mm Ball Bearing data come from?
Every value in this record is traced to a source — 3 documents including the board and chip datasheets — with the page and table cited per value. Unknowns are left explicit, never guessed.