Robot joints and actuation
8 mm bore thrust ball bearing (15.5 mm OD) supports a rotating shaft or joint and takes the load off the motor.
Engineering inference
goBILDA
goBILDA 8 mm Thrust Ball Bearing (15.5 mm OD)
goBILDA 1613-0516-0008 thrust ball bearing for 8 mm shafts and 8 mm lead screws: 8 mm bore (8.3 mm on the housing washer), 15.5 mm outer diameter, 4.96 mm thick, bronze cage with high-carbon steel washers and balls, 3.4 g. Takes axial load off the rest of an assembly; no load ratings are published.
1613-0516-0008Development boardPrice · lowest of 2 sellers$3.99www.gobilda.com · in stock
Buy at www.gobilda.com - www.gobilda.comin stock$3.99
- www.servocity.comin stock$3.99
Motor essentials
Facts about the complete product. Unknown values remain open design questions.
A good fit for
Guidance to help you shortlist. The basis is shown for each recommendation.
Linear motion and lifts
thrust ball bearing for an 8 mm shaft or lead screw in a linear axis or lift.
Engineering inferenceNo-load speed, rated performance and stall limits describe different operating points. A stall specification is not a continuous operating rating.
FAQ
goBILDA 8 mm Thrust Ball Bearing questions
How much does the goBILDA 8 mm Thrust Ball Bearing cost?
From $3.99 at www.gobilda.com (2 supplier offers tracked). Prices are observed unit prices before tax and shipping.
What are the goBILDA 8 mm Thrust Ball Bearing dimensions?
15.5 × 15.5 × 4.96 mm. A STEP model is available for enclosure fit checks.
Where does this goBILDA 8 mm Thrust Ball Bearing data come from?
Every value in this record is traced to a source — 3 documents including the board and chip datasheets — with the page and table cited per value. Unknowns are left explicit, never guessed.